Hytrol Catalog

CATALOG | 08312018 PCH OVERHEAD END DRIVE –Located on discharge end of conveyor. Chain guard located on right hand side. BELT –Piano Hinge metal belt with 12 ga. plain bottom aprons. 2 1/2 in. pitch chain with 1 1/2 in. dia. hardened rollers with 7/16 in. dia. hinge axle. 1 1/2 in. high x 10 ga. continuous off-set side wing links. BED –8 5/8 in. deep x 10 ga. powder painted, formed steel channel. Modular bed sections bolt together with butt couplings. 45 ° standard incline section. BELT GUIDES –Steel angle mounted inside bed for tracking belt. DRIVE SPROCKETS –5 in. pitch dia. with 1 7/16 in. dia. shaft, 6 tooth. TAKE-UP SPROCKETS –5 in. pitch dia. with 1 7/16 in. dia. shaft, 6 tooth. TAKE-UP– Take-ups are provided to insure proper belt tension. BEARINGS –Sealed, re-lube bearings at drive and take-up. SPEED REDUCTION – Sealed worm gear speed reducer driven by V-belt. No. 60 roller chain to drive sprockets. MOTOR – 1 HP -208/230/460/575V-3 Ph. 60 Hz Premium Energy Efficient with torque limiter (Not a warranty item). BELT SPEED –Constant 30 FPM. CAPACITY –35 lbs. belt capacity per linear foot of conveyor. FLOOR SUPPORTS –Now supplied as optional equipment. • OPTIONAL EQUIPMENT FLOOR SUPPORTS –PCHSType floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above PCHS-3 support. BELT –Perforated, pimpled, or pimpled and perforated. 1 1/2 in. or 2 in. high cleats. Contact factory. DRIP PANS –Mounted underneath conveyor frame for drainage. COVER –Mounted on top of conveyor frame to keep parts from falling back when conveyor is used at steep incline. INCLINES –30º, 45º, and 60º angles. Horizontal available. BED –2 ft. through 10 ft. intermediate beds available. MOTORS –Single phase, brakemotor, other characteristics. 2 HP maximum. ELECTRICAL CONTROLS –Magnetic starters, push button stations and AC variable frequency drive. BELT SPEED –Other constant and variable speeds. • STANDARD SPECIFICATIONS Model PCH design makes it ideal for positioning into or under punch presses and similar equipment. Horizontal discharge section allows easy positioning of hopper or drum for parts collection. Metal Piano Hinge belt provides continuous reliable service. Construction is heavy-duty with perforated apron plates and solid steel, heat-treated rollers.

RkJQdWJsaXNoZXIy NjQ0OTEy