Hytrol Catalog

CATALOG | 08312018 SL END DRIVE –Located at discharge end of conveyor. Chain guard located on left hand side. SLATS –Formed steel slat, 5 3/4 in. x 1 1/2 in. x 7 ga. channel. CHAIN –6 in. pitch bushed roller steel chain with 2 in. dia. high capacity roller bearing. BED –17 in. deep x 10 ga. formed steel channel powder painted. Standard 5 ft. and 10 ft. long sections bolt together with butt couplings. DRIVE SPROCKETS –12 in. pitch dia. with 2 15/16 in. dia. shaft. TAKE-UP –Take-ups provided at tail sprockets. Provides 15 1/2 in. of chain take-up. BEARINGS –Sealed, pre-lubricated, self-aligning, ball bearings at drive and tail sprockets. SPEED REDUCTION –Heavy-duty sealed worm gear C-Face speed reducer. No. 100 roller chain to drive sprocket. MOTOR –2 HP–230/460V–3 Ph. 60 Hz. Energy Efficient C-Face and AC variable speed controller with soft start capability and motor overload protection. CONVEYING SPEED –Constant 30 FPM. CAPACITY –Maximum load per linear foot of conveyor 1400 lbs. NOT TO EXCEED capacity in chart. FLOOR SUPPORTS –Now supplied as optional equipment. • OPTIONAL EQUIPMENT FLOORSUPPORTS –SLSandSLSDTypefixedfloorsupportsareavailable.Specifytopofslatelevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. SLAT –Wood, contact factory. MECHANICAL SHEAR PIN HUBS - Required if MD65 Controller is not used. ELECTRONIC SHEAR PIN - Required if MD65 Controller is not used. CONVEYING SPEED –Other constant and variable speeds available. Note : Capacity affected with speed change. Contact Factory. MOTORS –3 HP maximum. ELECTRICAL CONTROLS –Push-button stations. • STANDARD SPECIFICATIONS Detail shows inside view of roller chain which carries steel slats. Chain rides on steel angle mounted to conveyor side of channel. LOAD CAPACITY CHART @ 30 FPM HP SLATWIDTH SLATWIDTH 28" to 37" 43" & 49" TOTAL LOAD (LBS.) TOTAL LOAD (LBS.) UP TO 24' UP TO 49' UP TO 79' UP TO 24' UP TO 49' UP TO 79' 2 2400 850 – 2000 – – 3 6000 4400 2900 5600 3600 1700