Hytrol Catalog

CATALOG | 08312018 CRB BELT –Black Trackmate 533 COS. Clipper lacing. BED –Roller bed with 2 in. dia. x 12 ga. unplated tread rollers spaced every 6 in., or 12 in. mounted in 10 ga. painted formed steel channel frame with 12 ga. painted side guards extending 8 1/2”above belt. Sections bolt together with splice plates. END DRIVE –Located on discharge end of conveyor, chain guard on left hand side. BELT SCRAPER –Mounted in bed section to clean underside of return belt. DRIVE PULLEY –8 in. dia. with 1 3/16 in. dia. shaft at bearings–machine crowned and fully lagged. TAIL PULLEY –6 in. dia. with 1 3/16 in. dia. shaft at bearings–self-cleaning, crowned SNUB IDLER –Adjustable–2 1/8in. dia. Pre-lubricated ball bearings. RETURN IDLER –Adjustable–1.9 in. dia. Pre-lubricated ball bearings. TAKE-UP –Screw take-ups at tail pulley. Provides 4 in. of belt take-up. BEARINGS –Sealed, pre-lubricated, self-aligning, cast-iron ball bearings on drive and tail pulley. Sealed, pre-lubricated ball bearings in tread rollers. SPEED REDUCTION –Sealed worm gear“C”face speed reducer. No 50 roller chain to drive pulley. MOTOR –1 HP–208/230/460/575V–3 Ph.–60 Hz.– Premium Energy Efficient C-Face. BELT SPEED –Constant 65 FPM. CAPACITY –Maximum load per linear foot of conveyor–25 lbs. NOT TO EXCEED capacity in chart. FLOOR SUPPORTS –Now supplied as optional equipment. • OPTIONAL EQUIPMENT FLOOR SUPPORTS –MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MS-6 support. NOTE : Drive end support non-adjustable up to 16 in. elevation. BELT SPEED –Other constant and variable speeds. V-Belt drive supplied on speeds under 17 FPM. Note : Capacity affected with speed changes. CENTER DRIVE –Provides 16 in. of belt take-up. Minimum elevation 20 in. Specify location. Minimum OAL 66 in. V- BELT DRIVE –V-belt supplied between motor and reducer. O-RING DRIVE CHAIN –With sealed in lubricant (Recommended for applications that do not permit regular lubrication). END CAP –A formed steel end cap is bolted to inside of conveyor at tail end to keep material from falling off end of conveyor (not available with 7 in. extended guard rail.) CEILING HANGERS –5/8 in. dia. x 8 ft. long unplated rods fully threaded. Other lengths and galvanized rods available. MOTORS –Single phase, brakemotor–other characteristics. 2 HP maximum. ELECTRICAL CONTROLS –Non-reversing magnetic starters and push-button stations. AC variable frequency drive. LOAD CAPACITY CHART HORIZONTAL CONVEYOR ROLLER BED @ 65 FPM HP TOTAL LOAD (LBS.) UP TO 52' UP TO 102' 1 400 200 2 850 700 DETAIL VIEW OF SELF-CLEANING TAIL PULLEY • STANDARD SPECIFICATIONS

RkJQdWJsaXNoZXIy NjQ0OTEy