Hytrol Catalog

CATALOG | 03202019 BELT –High grip longitudinally grooved belt; NSL-11ESBV-U2 Endless Splice. BED –12 ga. galvanized slider pan mounted on a 17 in. x 12 ga. powder painted formed steel channel frame. SPRING TENSION TAKE-UP – 2 1/4" dia. take-up pulley; provides 16" of belt take-up. DRIVE PULLEY –8 in. dia. with 1 11/16 in. dia. shaft at bearings, lat-faced and non-lagged. BEARINGS –Sealed, pre-lubricated, ball bearings on drive. Precision bearings on tail shafts. MOTOR – 208/230/460/575V - 3 PH. - 60 HZ. Premium Energy Efficient C-Face. SPEED REDUCTION – Sealed worm gear C-Face speed reducer. No 60 roller chain to drive pulley. GAPPER-D FLOOR SUPPORT S–MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MS-6 support. GUARD RAILS –Adjustable Universal Channel Guard Rail, overlapping fixed channel (one direction). O-RING DRIVE CHAIN –With sealed in lubricant (Recommended for applications that do not permit regular lubrication). LENGTH –Optional 10’-0”long bed section with 60”long infeed and discharge segments. MOTORS –Single phase, brakemotor, other characteristics. ELECTRICAL CONTROLS –One direction manual start switch, non-reversing starters, push button stations. AC variable frequency drive. • OPTIONAL EQUIPMENT SGR 1.25 1.50 1.75 2.00 2.25 2.50 NOTE : As cartons pass from the infeed belt to the higher speed discharge belt, a gap is created between cartons according to the following formula: FORUMLA Length of Box + Final Gap --------------------------- = Speed Gap Ratio (SGR) Length of Box + Initial Gap Gaps are then measured and speed altered during release of cartons to create desired final gap or pitch. This process is required at each transition where there is a speed change. Discharge Belt Speed SGR = ------------------------------- Infeed Belt Speed LENGTH OF BOX INITIAL GAP FINAL GAP FLOW NOTE : Maximum operational speed will be limited to carton sizes being conveyed in order to prevent carton tumbling or sliding. Contact Factory for specific application limits. • STANDARD SPECIFICATIONS