Hytrol Catalog

CATALOG | 08312018 190-E24 BED (E24) —Roller bed with 1.9 in. dia. roller x 16 ga. galvanized tube and bearings spaced every 3 in. Mounted set-high in 6 1/2 in x 12 ga. powder painted formed steel channel frame bolted together with splice plates. BED (E24C) —Roller bedwith 21/2 in. dia tapered to 1 11/16 in. dia. x 14 ga. galvanized rollers. Mounted in 6 1/2 x 12 ga. powder painted formed steel channel frame. MOTOR —24VDC motor with integrated control card located along section on the inside of the BR on straight section only. Maximum slaved rollers is 16 per each motor. SLAVE O-RINGS —3/16in. dia. polyurethane o-rings slave-drive tread rollers from motor. POWER SUPPLY (FOR MOTORS) —40 amp DC power supply, 24 volt fixed output. Maximum of 40 motors per power supply. 120 vac, 8.6 amp input. Mounted near center of conveyor. Note : Number of motors per power supply is based on the use of standard Hytrol o-rings. Other o-rings are available that may increase load capacity, but reduce the number of motors that may be powered from one power supply. Contact factory for more information. CONVEYING SPEED —25-254 FPM, set on integrated motor control card. CAPACITY —Maximum 37 lbs. per foot with a maximum capacity per E24 motor of 75 lbs. If loading product“back to back”use the following chart: SECTION LENGTH NUMBER OF MOTORS IN SECTION CAPACITY (LBS PER FOOT) 2’-0” 1 37 2’-6” 30 3’-0” 25 3’-6” 21 4’-0” 19 4’-6” 2 33 5’-0” 30 5’-6” 27 6’-0” 25 6’-6” 23 7’-0” 21 7’-6” 20 8’-0” 19 8’-6” 3 26 9’-0” 25 9’-6” 23 10’-0” 22 NOTE : Capacity is based on the use of standard Hytrol o-rings. Other o-rings are available that may increase load capacity, but reduce the number of motors that may be powered from one power supply. Contact factory for more information. FLOOR SUPPORTS –Now supplied as optional equipment. • OPTIONAL EQUIPMENT FLOOR SUPPORTS –MS Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MS-6 support. POWER SUPPLY (MOTORS) —20 Amp power supply available. 20 motors maximum. 5 AMP power supply available. 3 motors maximum. 480 Volt Power Supplies also available. POLY-TIER SUPPORTS —36 in. to 120 in. support heights in 6 in. increments. Knee braces required. CEILING HANGERS —5/8 in. dia. x 8 ft. long unplated steel rods fully threaded. Other lengths and galvanized rods available. GUARD RAILS –Adjustable Universal Channel Guard Rail, type A & B angle. (See Accessory section.) NOTE : If product comes in contact with guard rails, product flow will be affected. MOTOR AND SEPARATE CONTROL CARD – Available with 3 Amp setting. TANGENTS - Slaved and Powered type available. Motors mounted on outside of channel. • STANDARD SPECIFICATIONS

RkJQdWJsaXNoZXIy NjQ0OTEy