Hytrol Catalog

CATALOG | 08312018 25-PVR BED –Roller bed with 2 1/2 in. dia. x 11 ga. unplated tread rollers spaced every 3 in., 4 in., or 6 in. roller centers only. Tread rollers mounted in 4 in. x 4 ga. powder painted formed steel channel on side opposite guard and 5 in. x 4 ga. powder painted formed steel channel on guard side. SHAFT MOUNTED DRIVE –Shaft mounted drive to the side of the bed section. POLY-V BELT –8-rib J-Profile roller to roller. GUARD –Formed steel, upper and lower guard mounted to top and bottom of channel frame to totally enclose drive belts. BEARINGS –Sealed, pre-lubricated ball bearings. MOTOR –1 HP–208/230/460/575V–3 Ph. 60 Hz. gearmotor. CONVEYING SPEED –Constant 30 FPM. CAPACITY –– Maximum load per linear foot of conveyor 300 lb. with supports on 10 ft. centers, 1000 lb. with supports on 5 ft. centers. Total load 3000 lbs. FLOOR SUPPORTS –Now supplied as optional equipment. CONVEYOR LENGTHS –Maximum 10’per drive. • OPTIONAL EQUIPMENT FLOOR SUPPORTS –HSN Type floor supports are available with a wide range of adjustment. Specify top or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above HSN-3 support. CONVEYING SPEED –Other constant and variable speeds. NOTE : Capacity affected with speed change. GUARD RAILS –Fixed angle (2 in. high x 1/4 in. steel) guard bolts to top flange of channel opposite guard. CHANNEL END STOP –6”x 8.2 lb. structural channel end stop. TRANSFERS –Chain transfers available. See Accessory section. MOTORS –Other HP gearmotors available. ELECTRICAL CONTROLS –Non-reversing magnetic starter – push-button stations. AC variable frequency drive. • STANDARD SPECIFICATIONS GUARD REMOVED TO ILLUSTRATE ROLL TO ROLL DRIVE BELT. WARNING: DO NOT OPERATE CONVEYOR WITH GUARD REMOVED.