Hytrol Catalog

CATALOG | 08312018 199-CRRC BED –Roller bed with 2 1/2 in. dia. tapered to 1 11/16 in. dia. x 14 ga. unplated rollers mounted in 10 ga. powder painted formed steel channel frame. CENTER DRIVE –Located on 4’-0”long straight section. ROLLER CHAIN –No. 40 circular roller-to-roller chain. MOTOR DRIVE CHAIN –No. 60 chain. CHAIN GUARD –Mounted to top of channel frame to totally enclose drive chain. BEARINGS –Sealed, pre-lubricated ball bearings. BUTT COUPLINGS –Standard for connecting to 199-CRR. SPEED REDUCTION –Sealed worm gear C-Face speed reducer. MOTOR –1/2 HP–208/230/460/575V–3 Ph. 60 Hz. Totally Enclosed C-Face. CONVEYING SPEED –Constant 35 FPM. CAPACITY –850 lbs. total distributed live load. FLOOR SUPPORTS –Now supplied as optional equipment. • OPTIONAL EQUIPMENT FLOOR SUPPORTS –MSN Type floor supports are available with a wide range of adjustment. Specify top of belt or roller elevation. One support required at every bed joint and ends of conveyor. Holes in feet for lagging to floor. Knee braces recommended above MSN-6 support. CONVEYING SPEED –Other constant and variable speeds. NOTE : Capacity affected with speed change. SHAFT MOUNTED DRIVE –Requires shaft mounted gearmotor. Minimum elevation top of rollers 6 in. O-RING DRIVE CHAIN –With sealed in lubricant (Recommended for applications that do not permit regular lubrication). ROLLERS SET LOW –Tread rollers mounted in 4 3/4 in. x 10 ga. formed steel channel frame to form 1 in. high guard rails. GUARD RAILS –Adjustable Universal Channel Guard Rail (both sides), fixed channel (both sides) or angle (one side). See Accessory section POLY-TIER SUPPORTS –36 in. to 120 in. support heights in 6 in. increments. Knee braces required. CEILING HANGERS –5/8 in. dia. x 8 ft. long unplated steel rods. Other lengths and galvanized rods available. MOTORS –Energy efficient, single phase, brakemotor, other characteristics. 1 HP maximum. ELECTRICAL CONTROLS –Non-reversing or reversible magnetic starters and push-button stations. AC variable frequency drive. • STANDARD SPECIFICATIONS